Facets on this elevation
Facets marked “not drawn” are in HOVER’s tables but too small or hidden to label on the drawing. They still count.
Wall area by material
By elevation
Siding trim & corners
Summed from the HOVER per-facet trim table for every facet currently set to siding or board & batten. HOVER did not itemize trim for its brick facets, so any of those you flip to siding show area only — see the note below the table.
Roofline (fixed — doesn’t change with materials)
Openings
Quick pricing check
Enter the contractor’s unit rates to see what his number should come out to. Leave blank to skip.
Tongue & groove ceilings
Porch and breezeway ceilings that get T&G instead of standard soffit. Each item can use HOVER’s measured soffit segment, the architect’s plan area, or your own dimensions. Vaulted ceilings get a slope factor.
Standard soffit
HOVER measured 148 soffit segments, 1,417 ft² total. Deep segments you’ve assigned to T&G above are removed here.
Deep soffit segments (24″ and deeper)
These are the candidates for porch ceilings. Toggle any that should be T&G.
Brick coursing pattern
Nicole’s pattern: runs of standard courses with a projecting half-brick accent course between them. Adjust and hand the mason the drawing.
Pattern drawing
Brick quantities
Notes for the mason
Contractor summary
Facet schedule
Every HOVER facet with its material. Facets under 3 ft² are folded into the totals but hidden here.
Sources
HOVER Complete Measurements, Cramer Residence, Property 21794512 / Model 21824156, 21 May 2026. Architect plan set “CRAMER RESIDENCE 20260122 FINAL” (A1.1 Main Floor Plan, A2.0/A2.1 Elevations) for covered porch 386 ft², covered patio 463 ft², breezeway 11′-1½″ wide, and the brick-wainscot / chimney brick intent. Label positions were read from the HOVER drawings; verify any label against the drawing before relying on it.